65240-004LF

The DUBOX 65240 series Connector families offer an extensive range of through-hole and surface-mount part options, including either straight or right angle orientation from 2 to 50 positions, with a current rating of 3A (maximum) per individual contact. The Dubox® contact has a pre-stressed, dual beam design to enable low insertion force, 4-wall contact design for signal protection. These are applicable in electronic equipment or devices requiring a parallel, planar or perpendicular board-to-board, wire to-board or flat cable interconnects. Uses span industry segments.

• Dual beam contact design
• Contact pre-stressed
• Mates with very short pins (5mm) stackable end-to-end and side-by-side
• Floating solder tails self centre on the circuit pads
• 4 wall contact design
• Duplex plating
• High reliable electrical performances
• Low insertion force required
• Meets your specific needs and is useful for Mezzanine Application
• Easy to assures the coplanarity
• Signal protection
• Maintaining the alignment for soldering and facilitates robotic placement
• Compatible with infrared and vaporphase reflow

Rakendused

Industrial